Gravely Lawn Mower Accessory 892031 User Manual download pdf (Page 11)

Install Front Baffle and Finger Guard on Blower

Assembly (Figure 10)

1. Remove one mounting bolt from the idler release

lever.

2. Choose the appropriate blower baffle according to

the table below (Figure 8) and then install the

blower baffle (item 6 or 7) with two 3/8-16 x 1/2

tapping screws (item 26).

3. Remove the blower cover.

4. Choose the appropriate finger guard according to

the mower deck size:

• 52-inch mower decks use part number 00483851 (1

notch, 8" long).

• 60 & 72-inch mower decks use part number

00491851 (3 notches, 5.50" long).

5. Install the finger guard with two 1/4-20 x 1/2 hex

bolts (item 21) and top-locking flange nuts

(item 20). Install the bolts so the nuts are inside the

blower.

6. Replace the cover. Make sure the safety decals

face outside where operators and bystanders can

see them.

Install Rear Baffle

1. Choose the appropriate baffle according to the

mower deck size as shown in figure 9.

2. Install baffle to blower assembly as shown in

figure 10.

Item Description Item Description

5 Counterweight* 12 Hair Pin

8 Weight Plate 23 Bolt 5/16-18 x 4-1/2

10 5/16" Wing Knob 25 23/64 / 3/8 x 3-1/4

Clevis Pin

Figure 7

ODd0326

Footrest

Figure 8

Mower Deck Baffle Measurements

52-Inch 5-3/4 Inches

60-Inch 2-7/8 Inches

72-Inch No Baffle Required

Front Blower

Baffle (item 6

or 7)

Figure 9

52"/60" Mower

Deck Baffle

72" Mower

Deck Baffle

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments

Gravely Lawn Mower Accessory 892031 User Manual Page 11

Comments to this Manuals