Gravely Lawn Mower Accessory 892031 User Manual download pdf (Page 15)

If hose or blower assembly gets clogged, stop forward

motion and allow unit to clear itself. If unit will not clear

itself, unclog the hose and/or blower assembly manually

as instructed below.

1. Stop engine and remove ignition key. Wait for all

moving parts to stop.

2. Remove hose from inlet on grass container.

(figure 15).

3. Remove hose from blower assembly.

NOTE: Perform steps 4 and 5 if clog is in the hose:

4. Remove clogged grass.

5. Reinstall hose.

NOTE: Perform steps 6 and 7 if clog is in blower

assembly.

6. Clear grass from blower assembly.

7. Reinstall hose and tighten hose clamp.

OPERATING TIPS

• Cut grass when it is dry.

• Cut grass in two passes when cutting thick, long, or

wet grass. Make the first cut higher than desired.

Make the second cut at desired height.

• Always use full throttle when bagging.

Gravely Dealers will provide any service or adjustments

which may be required to keep your unit operating at

peak efficiency.

MAINTENANCE SCHEDULE

The chart below shows the recommended maintenance

schedule that should be performed on a regular basis.

Check Fasteners

IMPORTANT: Be certain that all hardware is tight before

each use. Pay special attention to the guards and safety

shields. Check tool-less hardware often. Tighten as

needed.

Inspect Bagger Parts

Before each use, inspect bagger parts for any holes,

abrasions, or structural damage. Replace any worn or

damaged parts.

Clean Unit

Clear away grass build-up in bagger before and after

each use.

Check V-Belt

Check V-belt tension after initial first two hours of use and

every 10 hours thereafter. Check V-belt for wear every 10

hours; replace V-belt if worn or deteriorated (see

Replacing V-Belt (Figure 16) on page 15).

REPLACING V-BELT (FIGURE 16)

1. Remove belt cover.

2. Remove blower assembly from mower deck.

3. Remove old V-belt.

4. Install new V-belt on blower assembly pulley.

5. Install blower assembly to mower deck.

6. Route new V-belt onto double pulley (see Install

Blower Assembly on Deck on page 12).

WARNING: PINCH POINT! Use extreme

caution when unclogging blower assembly.

Impeller can cut or pinch your hand, even when

not in operation. Wear sturdy gloves when

working near impeller.

WARNING: Blades rotate when impeller rotates.

Impeller rotates when blades rotate. Block

blades to prevent rotation before proceeding.

MAINTENANCE

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

MAINTENANCE SCHEDULE

Service Performed Each Use Every 10 hrs.

Check Fasteners •

Inspect Bagger Parts •

Clean Unit •

Check V-belt •*

* Check V-belt tension after initial first two hours of use.

ODd0372

V-Belt

Blower

Assembly

Pulleys

Double

Pulley

Figure 16

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments

Gravely Lawn Mower Accessory 892031 User Manual Page 15

Comments to this Manuals