Gravely Lawn Mower Accessory 892031 User Manual download pdf (Page 9)

INSTALLATION

Adjust the Parking Brake

NOTE: The additional weight of the grass container

requires a parking brake re-adjustment.

1. Remove the rear wheels.

2. Set the spring length and return gap as shown

below.

3. Replace the rear wheels. Tighten the lug nuts to

51–72 lb-ft (69–97 N•m).

Assemble the Grass Container

Figure 4

NOTE: Use three or more people to install the collector

box on the main frame. The weight and bulk of the grass

collector make it difficult to install safely without

assistants.

1. Slide the lift handle (item 14) into the slot of the

handle mount bracket on the collector box.

NOTE: You may need to remove the grip on the lift

handle to fit the handle through the slot.

2. Connect the extension spring to the open hole in

the handle mount bracket and then to the lift handle

(item 14).

3. Connect the lift handle to the grass container with

one 3/8-16 x 2 hex bolt (item 27) and two 3/8-16

flange nuts (item 28).

4. Install the ball joint on the latch rod about half way

down the threads on the latch rod so some thread is

available for adjustment.

5. Connect the ball joint (item 29) to the latch hook on

the grass container with one 5/16-24 hex nut

(item 31) and one 5/16 lock washer (item 32).

6. Connect the latch rod to the lift handle with a

3/32 x 3/4 cotter pin (item 33).

Install the Mounting Frame and Grass Container

Figure 5

1. Remove the hardware holding the rear bumper to

the unit frame and then install the left lower frame

leg on the frame with three 3/8-16 x 3 hex bolts

(item 24) and 3/8 lock nuts (item 19). Repeat for the

right lower frame leg.

NOTE: Do not remove the bumper from the unit.

2. Install the main frame on the lower frame legs with

two 3/4-10 x 1-1/2 hex bolts (item 34) and two

3/4-10 nylon lock nuts (item 35) and with two

1/2-13 x 1 hex bolts (item 36) and two pivot frame

handles (item 37).

3. Have two people hold the grass container in

position while a third person connects the container

to the main frame with two detent pins (item 43),

two 5/8 flat washers (item 44) and two 5/32 x 2-5/8

hair clips (item 45).

Figure 3

OF3303

1-1/4-in.

(3.18 cm)

1/16-in. (1.59 mm)

Figure 4

31, 32

Item Description

14 Lift Handle

27 3/8-16 x 2 Hex

Bolt

28 3/8-16 Flange

Nuts

29 Ball Joint

30 Latch Rod

Item Description

31 5/16-24 Hex Nu

32 5/16 Lock

Washer

33 Rue Ring Cotter

42 Spring

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comments to this Manuals

No comments

Gravely Lawn Mower Accessory 892031 User Manual Page 9

Comments to this Manuals