Gravely Lawn Mower Accessory 892031 User Manual download pdf (Page 14)

REMOVING BAGGER KIT

1. Remove the hose from the blower assembly and

collector inlet (see figure 15 on page 13).

2. Remove belt cover.

3. Remove V-belt from double pulley (see figure 12 on

page 12).

4. Remove blower assembly (see figure 11 on

page 12).

5. Re-install belt cover.

6. Install discharge chute.

7. Remove counterweights (see figure 7 on page 11).

8. Remove grass container, mounting frame and

mounting legs (see figure 5 on page 10).

BEFORE EACH USE

1. Check bagger parts for wear, deterioration or

damage. Replace ONLY with Gravely original

service parts before operating.

2. Make sure counterweights are installed.

3. Make sure all hardware is tight.

IMPORTANT: Check tool-less hardware often. Tighten as

needed.

4. Remove any grass buildup from bagger parts.

5. Ensure hose is fastened securely on upper boot

and blower assembly.

BAGGING

Starting

1. Start engine and engage PTO according to unit

owner’s manual.

2. Set throttle to full.

3. Choose a slow ground speed.

Shut Off

1. Disengage PTO.

2. Shut off unit according to unit Owner/Operator’s

manual.

EMPTYING THE GRASS CONTAINER

If container stops picking up grass clippings, container

may be full.

To empty container:

1. Park the unit where you want to empty the

container.

2. Disengage PTO, stop engine and remove ignition

key. Wait for all moving parts to stop before leaving

operator’s position.

3. Pull the lift handle away from the grass container

and then lift upward. The container should pivot

backwards toward the ground and the door should

open, releasing container contents.

4. Clean out hose.

5. Pull the lift handle back and down to pivot the

container upright and to close the door.

6. Push the lift handle in towards the container to lock

the door latch in place.

IMPORTANT: Make sure the container door latches

securely.

UNCLOGGING GRASS CONTAINER

REMOVAL

CAUTION: Deflected material may cause injury.

ALWAYS operate mower with bagger cover

closed and secured, blower assembly fastened

securely, or with chute deflector in operating

position.

CAUTION: Always install counterweights on

front axle before operating unit with bagger

attached. Always remove counterweights from

front axle when bagger is removed from the unit.

OPERATION

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

WARNING: Lower attachment, stop engine, and

remove key to prevent unauthorized use. DO

NOT park on slopes.

WARNING: MOVING PARTS can cut or

amputate body parts.

NEVER attempt to clear blower assembly while

engine is running.

ALWAYS stop engine, remove key, and wait for

moving parts to stop.

Sharp edges can cut. Movement of parts can

cut off fingers or a hand. Wrap blade(s), wear

sturdy gloves and use extreme caution when

working near blades or impeller.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Comments to this Manuals

No comments

Gravely Lawn Mower Accessory 892031 User Manual Page 14

Comments to this Manuals